Explore. Understand.
Stay ahead.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7921: Add PCIe AER handler support to prevent system crash When an AER error occurs and the bus is hung, the register reads return 0xFFFFFFFF, causing the DMA queue state to be corrupted and resulting in an invalid memory access when accessing q->desc[] or q->entry[]. Unable to handle kernel paging request at virtual address ffffffc01099eac0 pc : mt76_dma_add_buf+0x124/0x188 [mt76] lr : mt76_dma_rx_fill+0x11c/0x1d8 [mt76] sp : ffff…

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt792x: Fix memory leak in SDIO TX path When tx_prepare_skb() returns an error in the SDIO TX path, the skb is not freed, leading to a memory leak. This can occur when zero-length frames (such as WNM NULL frames) are dropped to prevent potential hardware TX hangs. Fix this by properly releasing the skb with ieee80211_tx_status_ext() when tx_prepare_skb() fails.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: fix RX data queuing of RRO 3.0 For RRO 3.0, RX data released from a RRO data queue should be put to the indicator queue. The frames are processed and completed in the context of the indicator queue NAPI, which only polls skbs queued on the MT_RXQ_RRO_IND list; frames queued under the data queue id are left sitting on that list until the data queue NAPI happens to run, stalling and reordering RX data.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: fix MLD ID in MAC TXD and HIF TXP Problem: MCU command timeout while the firmware state is normal, and the firmware keeps showing the error log "ERROR!! NO PAUSE...". Root cause: If the MLD_ID field in the TXD is neither the primary link id nor the secondary link id, it may lead to a firmware busy loop when the third link is in power saving mode. Remap frames directed to a third link to the primary link wcid. Since TX status…

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: fix non-AQL packet accounting for MLO stations __mt76_tx_queue_skb() overrides the wcid passed by the driver with sta->drv_priv, so the wcid might incorrectly be changed after TX, causing wcid->non_aql_packets to be counted on the wrong wcid. For example, on the AP side, if a station's setup link is the 5G link and the station uses 2G to transmit a frame, the value of non_aql_packets is increased on the 5G wcid but decreased on the 2G…

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: validate RX band_idx before dereferencing phys[] band_idx comes from a 2-bit descriptor field (0-3) and was used directly to index dev->mt76.phys[] (size __MT_MAX_BAND == 3) and dereference the result. A corrupt or reserved descriptor value could index out of bounds or hit a NULL phy on parts with fewer bands. Reject invalid band indices, mirroring mt7996_rx_get_wcid().

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7915: clear wcid mask under mutex after RCU pointer clear mt7915_remove_interface() cleared the wcid mask bit with no lock held and before clearing the RCU wcid pointer. The mask is a non-atomic RMW shared with the allocators, which all run under dev->mt76.mutex; on DBDC the two wiphys share one mt76_dev, so this raced add_interface/sta_add on the other band and could leak or double-hand-out a wcid. Clearing the bit before the RCU p…

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7915: avoid nss underflow in mt7915_mcu_get_sta_nss If a peer's VHT/HE MCS map has no supported spatial stream (all fields 0x3), the loop exits with nss == 0 and the function returned (u8)-1 (255), which was then written into the firmware sta_rec_bf beamforming fields. Clamp the result to 0.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: fix RXDMAD_C buffer recycling race The RXDMAD_C buffers come from the RRO data queues' page pools, which are bound to a different NAPI, so the direct page-pool recycle used here could race the owning NAPI; take the non-direct path as is already done for WED RX queues.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: bound TLV walk in mt7996_mcu_get_chip_config The response TLV loop advanced by tlv->len without a minimum, so a theoretical firmware response containing a zero-length TLV could spin forever, hanging the CPU during device probe. The u32 payload was also read without bounds checking. Reject a short fixed field, stop on a TLV whose length underruns the header or overruns the skb.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: fix out-of-bounds access in mmio copy helpers mt76_mmio_write_copy() and mt76_mmio_read_copy() iterate up to ALIGN(len, 4), so a length that is not a multiple of four reads past the source buffer (write_copy) or writes past the destination (read_copy). Copy the aligned body in the loop and handle the remaining tail through a 4-byte bounce buffer, keeping the register access width unchanged.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7915: unwind state on add_interface failure When mt76_wcid_alloc() fails, mt7915_add_interface() returned without clearing the vif_mask/omac_mask bits it had already set, without removing the firmware dev info added earlier, and without clearing a monitor_vif pointer to the vif mac80211 is about to free. mac80211 does not call remove_interface() for a failed add, so the indices and firmware dev entry leaked permanently and testmode …

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: hold dev->mt76.mutex while disabling tx worker in SER mt7996_mac_reset_work() parked the tx worker and disabled the RX/TX NAPIs before taking dev->mt76.mutex. mt76_worker_disable()/_enable() are plain kthread park/unpark, not refcounted, and __mt76_set_channel() toggles the same worker and the MT76_RESET bit under the mutex. An L1 SER racing a channel switch could therefore have the worker unparked and MT76_RESET cleared while…

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: reserve space for the CSA-abort countdown TLV When a CSA countdown is active, mt7996_mcu_beacon_cntdwn() emits two bss_bcn_cntdwn_tlv entries (the CSA countdown and the CCA-abort BCC), but MT7996_BEACON_UPDATE_SIZE only reserved one. With MBSSID enabled and a near-maximum beacon template the extra 8 bytes could push the offload command past MT7996_MAX_BSS_OFFLOAD_SIZE and trigger skb_over_panic(). Reserve room for both countdo…

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: cancel reset and rc work on device unregister Both drivers cancelled dump_work on unregister but left reset_work and rc_work to be flushed only by destroy_workqueue() in mt76_free_device(), which runs after the hw is unregistered and the hardware stopped. A reset_work that fires in that window calls ieee80211_restart_hw() and re-arms mac_work on an unregistered hw, and rc_work touches station state being torn down. Cancel both up fron…

In the Linux kernel, the following vulnerability has been resolved: ACPI: processor: Unregister cpufreq notifier on init failure acpi_processor_driver_init() registers the cpufreq policy notifier before registering the ACPI processor driver and setting up CPU hotplug state. If driver_register() or cpuhp_setup_state() fails, the error path only unregisters the ACPI processor driver and the idle driver. The cpufreq notifier remains registered even though initialization failed. Mirror the module exit path on the i…

In the Linux kernel, the following vulnerability has been resolved: drm/msm: don't tear down KMS twice when KMS init fails When priv->kms_init() (mdp4_kms_init() / mdp5_kms_init()) fails partway through, both display drivers already tear their KMS state down via mdp4_destroy() / mdp5_kms_destroy() before returning the error. The common error path in msm_drm_init() then runs msm_drm_uninit() -> msm_drm_kms_uninit(), which tries to destroy the very same KMS a second time, which causes a use-after-free crash. Bring…

In the Linux kernel, the following vulnerability has been resolved: drm/msm/dsi: Drop dev_pm_opp_set_rate(0) dev_pm_opp_set_rate(0) removes the vote specified in required-opps but does not actually park the clock, making it run without the necessary power backing. Drop the explicit call to it. Every call site of ops->link_clk_disable() is followed by pm_runtime_put(), so the power vote will be rescinded if deemed safe. Patchwork: https://patchwork.freedesktop.org/patch/742783/

In the Linux kernel, the following vulnerability has been resolved: wifi: ath11k: fix leak in ath11k_service_ready_ext_event() Currently, during ath11k_service_ready_ext_event() processing, svc_rdy_ext.mac_phy_caps can be allocated during TLV parsing. This is a temporary allocation that is freed on the success path, but not on the error path. If parsing succeeds far enough to allocate mac_phy_caps and then fails on a later TLV, the allocation leaks. So free the allocation on the error path. Compile tested only.

In the Linux kernel, the following vulnerability has been resolved: regulator: core: use system_freezable_wq for init complete work schedule_delayed_work() uses system_wq, which is non-freezable, allowing regulator_init_complete_work to run concurrently with system suspend. This work fires ~30s after boot to disable unused regulators via I2C. When it races with PM suspend, the I2C adapter may already be suspended, triggering a -ESHUTDOWN warning in __i2c_transfer(): WARNING: ... at __i2c_transfer+0x36c/0x3c8 …

In the Linux kernel, the following vulnerability has been resolved: bpf: Reject >8 byte return values on return-reading trampoline paths btf_distill_func_proto() builds the function model used for the fentry/fexit/fmod_ret/fsession trampolines and struct_ops. It has accepted a 16-byte __int128 return value since the trampoline was introduced: __get_type_size() returns the integer's type size, and the return-type check only rejected ret < 0. But the BPF trampoline preserves only 8 bytes of the return value (RAX o…

In the Linux kernel, the following vulnerability has been resolved: bpf, x86: Fix trampoline stack size for 128-bit arguments btf_distill_func_proto() accepts a function argument up to 16 bytes, so a 128-bit scalar such as __int128 reaches the x86 trampoline with arg_size == 16. But the current implementation assumes an __int128 argument only needs one register, so the register save area is under-allocated and save_args() overwrites adjacent stack slots. Compute the register count from arg_size for all arguments…

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7915: unlink TWT flow if the MCU rejects the agreement The flow is added to dev->twt_list before sending the agreement to the firmware, but the error path leaves it linked while flowid_mask is never set. The flow slot can then be reused and memset while still on the list, corrupting twt_list, and station removal leaves a dangling entry behind that mt7915_mac_twt_sched_list_add() later walks.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: free vif links after clearing wcid entries on full reset mt7996_mac_reset_vif_iter() queues non-default vif links for kfree_rcu while dev->wcid[] still holds pointers to the wcid embedded in each freed link; mt76_reset_device() then dereferences those entries and runs mt76_wcid_cleanup() on them. If a grace period elapses in between, the cleanup operates on freed memory. Run mt76_reset_device() first, so the wcid entries are …

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: clear stale link state on full reset After a full chip reset, mac80211 reconfig replays interface, link and channel context setup. mt7996_vif_link_add() short-circuits when the link_id is still marked in mvif->valid_links, a state introduced for postponing link teardown to interface removal. The reset path frees the link structures without clearing those bits, so the replayed setup never re-creates dev_info/bss_info/STA record…