← Back to CVE Explorer

CVE-2026-79978

Full vulnerability record from the local CVENow database.

Description

The RTIO streaming completion callback adxl345_process_fifo_samples_cb() in drivers/sensor/adi/adxl345/adxl345_stream.c clamps the amount of FIFO data it will report (read_len = MIN(fifo_bytes, buf_avail)) to the space actually returned by rtio_sqe_rx_buf(), but then queues one 6-byte bus read per hardware FIFO entry at consecutive offsets from read_buf, bounded by the device-reported entry count rather than by the clamp. When the allocated buffer is smaller than a full batch, the driver writes up to 186 bytes past the end of the allocation; a companion defect left data->fifo_total_bytes un-reset at batch start, so an aborted or errored chain could leave a stale write offset that pushes the next batch's writes out of bounds as well. A short buffer is an expected, first-class outcome of the RTIO allocator: rtio_block_pool_alloc() walks the requested size down one block at a time until a contiguous run is available, and the driver only demands sizeof(struct adxl345_fifo_data) + 6 bytes as its minimum. Any streaming configuration whose mempool block granularity is smaller than a full FIFO batch (204 bytes) — for example the sensor shell's RTIO_DEFINE_WITH_MEMPOOL(sensor_read_rtio, 8, 8, 32, 64, 4) used by sensor stream <dev> on fifo_wm incl, or the 16-byte-block streaming example in the documentation — takes this path whenever the pool is fragmented or the consuming thread falls behind. The out-of-bounds writes are performed by the I2C/SPI RTIO backend (DMA on many SoCs) into the shared RTIO block pool, corrupting neighbouring live buffers or, for a pool smaller than one batch, memory beyond the pool itself. The written bytes are accelerometer samples and the destination follows the allocation, so there is no controllable corruption primitive: the realistic impact is silent corruption of other RTIO consumers' data or a crash. Reaching it requires a board with an interrupt-wired ADXL345 built with CONFIG_ADXL345_STREAM, plus buffer-pool starvation, which a co-resident local workload can induce but which also occurs spontaneously under load; there is no network, USB or radio path to this code.

Severity
LOW
CVSS score
3.6 (v3.1)
Vulnerability status
Awaiting Analysis
Source identifier
Published
2026-10-23 20:17:27.657000
Last modified
2026-10-26 13:52:21.763000
View original CVE JSON
{
  "id": "CVE-2026-79978",
  "sourceIdentifier": "[email protected]",
  "published": "2026-10-23T20:17:27.657",
  "lastModified": "2026-10-26T13:52:21.763",
  "vulnStatus": "Awaiting Analysis",
  "cveTags": [],
  "descriptions": [
    {
      "lang": "en",
      "value": "The RTIO streaming completion callback adxl345_process_fifo_samples_cb() in drivers/sensor/adi/adxl345/adxl345_stream.c clamps the amount of FIFO data it will report (read_len = MIN(fifo_bytes, buf_avail)) to the space actually returned by rtio_sqe_rx_buf(), but then queues one 6-byte bus read per hardware FIFO entry at consecutive offsets from read_buf, bounded by the device-reported entry count rather than by the clamp. When the allocated buffer is smaller than a full batch, the driver writes up to 186 bytes past the end of the allocation; a companion defect left data->fifo_total_bytes un-reset at batch start, so an aborted or errored chain could leave a stale write offset that pushes the next batch's writes out of bounds as well.\n\nA short buffer is an expected, first-class outcome of the RTIO allocator: rtio_block_pool_alloc() walks the requested size down one block at a time until a contiguous run is available, and the driver only demands sizeof(struct adxl345_fifo_data) + 6 bytes as its minimum. Any streaming configuration whose mempool block granularity is smaller than a full FIFO batch (204 bytes) — for example the sensor shell's RTIO_DEFINE_WITH_MEMPOOL(sensor_read_rtio, 8, 8, 32, 64, 4) used by sensor stream <dev> on fifo_wm incl, or the 16-byte-block streaming example in the documentation — takes this path whenever the pool is fragmented or the consuming thread falls behind.\n\nThe out-of-bounds writes are performed by the I2C/SPI RTIO backend (DMA on many SoCs) into the shared RTIO block pool, corrupting neighbouring live buffers or, for a pool smaller than one batch, memory beyond the pool itself. The written bytes are accelerometer samples and the destination follows the allocation, so there is no controllable corruption primitive: the realistic impact is silent corruption of other RTIO consumers' data or a crash. Reaching it requires a board with an interrupt-wired ADXL345 built with CONFIG_ADXL345_STREAM, plus buffer-pool starvation, which a co-resident local workload can induce but which also occurs spontaneously under load; there is no network, USB or radio path to this code."
    }
  ],
  "affected": [
    {
      "source": "[email protected]",
      "affectedData": [
        {
          "vendor": "zephyrproject",
          "product": "zephyr",
          "defaultStatus": "unaffected",
          "collectionURL": "https://github.com/zephyrproject-rtos/zephyr",
          "packageName": "zephyr",
          "programFiles": [
            "drivers/sensor/adi/adxl345/adxl345_stream.c"
          ],
          "programRoutines": [
            {
              "name": "adxl345_process_fifo_samples_cb"
            }
          ],
          "versions": [
            {
              "version": "4.0.0",
              "lessThanOrEqual": "4.4.2",
              "versionType": "semver",
              "status": "affected"
            }
          ]
        }
      ]
    }
  ],
  "metrics": {
    "cvssMetricV31": [
      {
        "source": "[email protected]",
        "type": "Secondary",
        "cvssData": {
          "version": "3.1",
          "vectorString": "CVSS:3.1/AV:L/AC:H/PR:L/UI:N/S:U/C:N/I:L/A:L",
          "baseScore": 3.6,
          "baseSeverity": "LOW",
          "attackVector": "LOCAL",
          "attackComplexity": "HIGH",
          "privilegesRequired": "LOW",
          "userInteraction": "NONE",
          "scope": "UNCHANGED",
          "confidentialityImpact": "NONE",
          "integrityImpact": "LOW",
          "availabilityImpact": "LOW"
        },
        "exploitabilityScore": 1.0,
        "impactScore": 2.5
      }
    ]
  },
  "weaknesses": [
    {
      "source": "[email protected]",
      "type": "Secondary",
      "description": [
        {
          "lang": "en",
          "value": "CWE-787"
        }
      ]
    }
  ],
  "references": [
    {
      "url": "https://github.com/zephyrproject-rtos/zephyr/commit/3451bb1e1e9165844060551164adb8a756e7b6b7",
      "source": "[email protected]"
    },
    {
      "url": "https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-4v56-r4qm-v964",
      "source": "[email protected]"
    }
  ]
}